Samsung Galaxy Note 3 has a 5.7″ Super AMOLED 1080p display. It is powered by a 2.3GHz Snapdragon 800 processor, with 3GB of RAM. Storage comes in at 32GB or 64GB, which can also be expanded with a 64GB microSd card. The camera is an impressive 13MP and is capable of capturing 4K video. The Galaxy Note 3 retains the S Pen stylus, and is the first smartphone to include support for USB 3.0. All this is powered by a 3200mAh battery.
The LTE version of the Note 3 can be updated to Android 5.0 Lollipop via the leaked firmware. The build version of the leak is N9005XXUGBNL8, which weighs in at 1.10GB. OTA update will be out soon. But instead of waiting for OTA, you can manually install it. Follow the guide given below.
Disclaimer: Follow the instructions at your own risk. The writer cannot be held responsible for any bricked or unusable devices. Even though the chances of your Smartphone getting bricked are negligible, the owner of the device must take full responsibility of it!
Pre-requisites and Backing up your Galaxy Note 3 LTE:
- Make a Backup of the SMSs, Call logs and Contacts using the Super Backup App
- Make a Backup of the data on your phone
- Enable USB debugging on your device
- Make sure the device has at least 60% charging
- Backup WhatsApp messages on Android Smartphone and Email
Steps to install Android 5.0 on Galaxy Note 3 LTE:
- Make a backup of your data.
- Extract the contents of Odin3 3.09.zip on your computer and install Odin on the PC.
- Turn off the phone and make sure it is not connected to the computer.
- Boot the phone into Download Mode by switching it off and then simultaneously pressing the Volume Down + the Home key button. While holding these both buttons, you need to switch on your device.
- Open Odin. Connect your phone to the computer and allow the drivers to install. You will see the “Added!!” message on Odin. If it doesn’t appear, make sure you have properly installed the USB drivers for your phone.
- In the Odin Menu, make sure to check the Auto-Reboot and F.Reset options.
- Download the firmware zip file on the computer. Extract it and you will get a file with .tar.md5 extension.
- Click the AP button in Odin and select the file extracted in the previous step. Do not make any unnecessary changes on Odin.
- Click the Start button in Odin and wait for a few moments.
- Phone will automatically reboot. Done !