The Samsung Galaxy Tab 3 7.0 is powered by an Exonys 1.2GHz dual core processor. It runs on 1GB of RAM. It has 8GB of internal storage. It is equipped with wide angle camera and runs on Samsung Touchwiz software. It runs on Android 4.1 Jelly Bean OS.

The Samsung Galaxy Tab 3 7.0 users can manually update to the latest Android 4.3 Jelly Bean OS. For this purpose, you must first have root access on your device. Additionally, there are various benefits of rooting your device. So if you want to root your tablet, then follow the instructions below. The rooting procedure is same that is used for most Samsung devices i.e via the Odin.

Galaxy Tab 3 7.0

Note: This procedure is only for the 7″ Galaxy Tab. Do not use it for the 8″ and 10.1″ Galaxy Tab.

Disclaimer: Follow the instructions at your own risk. The writer cannot be held responsible for any bricked or unusable devices. Even though the chances of your device getting bricked are negligible, the owner of the device must take full responsibility of it!

Pre-requisites and Backing up your Galaxy Tab 3:


Steps to Root Galaxy Tab 3:

  1. Extract the contents of Odin3 on your computer and install Odin on the PC.
  2. Turn off the tablet and make sure it is not connected to the computer.
  3. Boot the tablet into Download Mode by holding the home button, volume down and power all at the same time. Then press the volume up button.
  4. Open Odin. Connect your tablet to the computer and allow the drivers to install. You will see the “Added!!” message on Odin. If it doesn’t appear, make sure you have properly installed the USB drivers for your tablet.
  5. Download PreRooted_SM-T211XXAMGL.tar.md5 zip file to the computer and extract the downloaded zip to get a file with .tar.md5 extension.
  6. Click the PDA button in Odin and locate the TAR file for your tablet. Do not make any unnecessary changes on Odin. Doing so will brick your tablet!
  7. Click the Start button in Odin.
  8. Your tablet will automatically reboot. You will also see the “PASS” message on Odin.
  9. Once the Samsung logo appears on the screen, you can disconnect your tablet from the computer.
  10. Now restart the tablet.
  11. Open SuperSU and update the binaries. Done!

You might also like these post :

About Lazy Smurf

I am a tech geek. I keep myself updated with all the recent happenings in the smartphone world. | Add my circles on Google+ :

Leave a Reply

Your email address will not be published. Required fields are marked *